My first attempt at Lazertran

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I know the thread is old but I had the great idea of doing some testing with my lazertran on a missed faceplate before I start baking my real GSSL faceplate.
I turned out to be really ugly. I tried to stick to the instruction the seller gave me (which are a bit different than yours actually) in my domestic oven and the edges of the paper can be seen pretty easily... How did you proceed with the cutting because it looks like yours edges are completely invisible! Plus, my paper turned slightly brown but that's another problem.
Did you pre-baked at 50 degrees your faceplate right after placing the decals?
 
Hi all

I tried that very method and the decals started to turn brown or "antique" as they call it when I was at the 170°C stage...
I will give it another try and will pay a lot of attention at that very moment so I can prevent them from turning brown... I like antique but on a brand new GSSL aluminium faceplate it is not looking good I think :)
 
Back
Top