buschfsu
Well-known member
does this sound ok...
use International Power Linear Power Supply +48V 0.5A PWR SPLY
this power supply (48v regulated) split parallel between the two phantom power suplly inputs on two separate channels of hamptone jfet and a step down power transformer (2:1) to get me to 24V regulated and take that parallel to the circuit inputs on both jfet mic pres. (do i need any passive components other than the iron?)
I want two channels of hamptone jfet (tape op article) using only one power supply. (the artilce mentions a 24V wall wart and regulators). I don't want to use the wall wart and the 48v regulated supply.
If i have this right the regulated supplies will push 48v and 24v respectivley to both boards but the current draw will increase, hopefully not more than the rated 0.5A?
this is going into a 2u case.
use International Power Linear Power Supply +48V 0.5A PWR SPLY
this power supply (48v regulated) split parallel between the two phantom power suplly inputs on two separate channels of hamptone jfet and a step down power transformer (2:1) to get me to 24V regulated and take that parallel to the circuit inputs on both jfet mic pres. (do i need any passive components other than the iron?)
I want two channels of hamptone jfet (tape op article) using only one power supply. (the artilce mentions a 24V wall wart and regulators). I don't want to use the wall wart and the 48v regulated supply.
If i have this right the regulated supplies will push 48v and 24v respectivley to both boards but the current draw will increase, hopefully not more than the rated 0.5A?
this is going into a 2u case.