Line level mix with "sub outs" Q?

moccasin · Jan 20, 2006

Hello,
I am gathering parts to build the line level mixer seen here:
http://home.comcast.net/~markfuksman/hamptone.jpg

I would like to have "sub outs" or another output bus.

Do i need an output xformer that has two secondary taps?

I have looked over the archives, and all of NYCDaves mixer schematics, but I dont see any with a separate set of outputs?

thanks in advance,
ry

*edited for spelling errors, and I simplified my question.

moccasin · Jan 21, 2006

OK,
Is the solution as simple as splitting the output of the "line level mixer" with a special cable? Or insert another transformer and output jack after the JFP stage?

thanks again,
ry

Viitalahde · Jan 21, 2006

Well, an Y-cable would be a ghetto solution that works.

A 1:1+1 transformer wouldn't be bad either. What kind of loads you'd be driving with that thing.

moccasin · Jan 21, 2006

Thanks,
I am building a small discrete channel strip type project:
hamptone mic pre-> EQ -> tape opto compressor.

It would be driving the gate of the fet, with the 10M resistor to ground on the Jfet micpre.

regards,
ry

Line level mix with "sub outs" Q?

Help Support GroupDIY Audio Forum:

moccasin

Member

moccasin

Member

Viitalahde

Well-known member

moccasin

Member

Similar threads

Latest posts

Line level mix with "sub outs" Q?

Help Support GroupDIY Audio Forum:

moccasin

Member

moccasin

Member

Viitalahde

Well-known member

moccasin

Member

Similar threads

Latest posts

Join the conversation!

Join today and get all the highlights of this community direct to your inbox. It's FREE!