i'm installing some of these in my current project and something isn't adding up correctly
i'm using the m2024 as illustrated on the bottom of page 3...
http://www.nkkswitches.com/pdf/MtogglesBushing.pdf
in continuity tests i'm not getting the results that are in the diagram
or maybe i don't understand an on on on switch properly. in two of the positions i'm getting the same results, and in the center position i get no continuity.
i'm using the m2024 as illustrated on the bottom of page 3...
http://www.nkkswitches.com/pdf/MtogglesBushing.pdf
in continuity tests i'm not getting the results that are in the diagram
or maybe i don't understand an on on on switch properly. in two of the positions i'm getting the same results, and in the center position i get no continuity.