I just finish a Rev A and I begin the calibration. My problem is step 3 : I follow the instructions, but when I have to turn R44 (Trimmer 5K) to fix -10dB, nothing happen...
R44 doesn't work....
I check all but I dont see anything.... Step 1 and 2 are good....
I find something... I had a stereo link card
on it... And at the step 3, when R44 doesn't work, I push the stereo switch, and now R44 is working BUT I cant see the -10 dB drop anymore, no more compression. To see the 10 dB drop, I have to push stereo switch again, compression is back BUT R44 doesn't work at thistime
I check + 10x everything but I can't find !
So I disconnect the stereo PCB. I plug the wire from the output pot to Ratio Bord pad 15 as a normal wiring, and calibration is OK ! R44 works perfecly but my 1176 has no stereo sidechain.
So the problem is from my Stereo link wiring ? stereo switch ? ... I cant see !!
Someone can help please ?
Here are some picture if you see something wrong, please tell me _IGP5976
, sur Flickr_IGP5977
, sur Flickr_IGP5981
, sur Flickr_IGP5978
, sur Flickr_IGP5983
, sur Flickr_IGP5982
, sur Flickr