ADM Output Transformer

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

CJ

Well-known member
GDIY Supporter
Joined
Jun 3, 2004
Messages
15,657
Location
California
observe:
this transformer is about to undergo a hair raising experience>
2vd0269.jpg
 
dang porn heads are cloggin up the wifi!

everytime i try to upload at nite, i have to wait for the "large breasted red head takes it deep"  file :mad:

whats a mother to do?  :D

ok t hen, srew the boss do it in the morning,

2lcb3o.jpg


n1xh6b.jpg


if5s0o.jpg


2yypd9c.jpg


notice the eye ring instead of a solid solder connection for the core ground wire, beginning of the end,

right after this, cd's came out,  :-\

5fnmz5.jpg




 
thanks for doing all these CJ! 
same as neve output,

do you have info on this? Actually do you have pics/info on your past kills? Can we request reposts?  :D  I think I already asked that, but what the heck, I'll be (even more) annoying today.  8)
 
search and ye shall find...

http://www.groupdiy.com/index.php?topic=4242.0

pics are down while vacuumbrain.com is held hostage.

ed
 
Would ya look at that!  I didn't even think to search for it, just quoted CJ since he mentioned it, but by reposts I was implying the API output hack/photos which I tried subtly to request in another thread, since I had a couple wound locally with just the info you and CJ gave me and others a while back...  After paying for 2 one-offs that couldn't pass gas without distorting I figured I'd show the guy the family album before shelling out more bucks (first time they even made a mistake mistook impedance for DCR but still charged me for the re-do). OK, sorry for the derail, carry on folks!
 
this was a varnish dip thing, not good, because

a) it stinks when you heat it

b) it keeps the supermalloy from expanding and contracting during heavy bass notes, mangnetorestriction

c) it means i can not re use the 80 Ni 

there were a couple of keeper lams on this stack they have rounded heels, like my girl,  :D

took me about 3 hours to de laminate this thing, i must be slippin,  utc lams just fall on the floor,

2rdf5o5.jpg


i put the I bar on there so Ed does not have a heart attack,  :D

ege4bs.jpg


splices all over the place, oh wonderful.  :eek:

20px8bt.jpg


i snapped a splice while un-peeling the tape, varnish is like that, anyway, it has the foil markers,

both splices have to come over the outer  layer,

14mcdxu.jpg


outer layer, heavy wire,>
i5vxgo.jpg


you have to saw thru the interlayer insulation, with wax, the paper slides right off with the heat gun,

2ymvprq.jpg

thinner wire used inside to balance the dcr>


1749ir.jpg


getting close to the first layer
9fqoog.jpg
 

Latest posts

Back
Top