[Mako 1176 RevJ] Questions about Hairball Pushbuttons

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Gege

Active member
Joined
Nov 8, 2008
Messages
28
Location
Lille - France
Hi,

I just received my HairballAudio package with Pushbuttons Banks and PCB.
I have 2 questions and I don't found answer.

One :
In this 2 links :
http://hairballaudio.com/docs/FET_Compressor_PCB_Board_Info_V2.pdf

http://mnats.net/1176_pushbutton_boards.html

i can't see the connection between Mnats R90, R88, R80, R78, R77, R50, R47, R27, R22, R5, R1 and Hairball R1, R2, R3, R4, R5, R6, R7, R8, R9 and R10.

Two :

On the mnat's wiring guide i read the CCW Release pot go to the "REL" point on the RATIO BOARD. But on this board, this point i named "18".
Electrically it is the same thing, but it's preferable that I connect this point on the main PCB 18 or on the CCW RelPot ??



Thanks.
 
Use this newer version as your guide:
http://www.hairballaudio.com/docs/FET%20Compressor%20PCB%20Board%20Info%20V3.pdf

I'll see if I can find something with the "J" values on it.

Mike
 
Thank you for feedback

I've did your schematic, but I don't have a 150R in 500mW (only 250mW) ? Big problem ?


Off topic: I received my order from you and the care package was not very well protected. a top plate was a bit damaged: (

Watch out for upcoming selling
 
Gege said:
Thank you for feedback

I've did your schematic, but I don't have a 150R in 500mW (only 250mW) ? Big problem ?


Off topic: I received my order from you and the care package was not very well protected. a top plate was a bit damaged: (

Watch out for upcoming selling

Not a problem with 1/4W.

If anything arrives damaged you should email me and I'll replace it.

Mike
 
Don't worry, it's just the (little little little) corner of the top plate ... a few secondes with a protected clamp and it's invisible.

The front plate of your case is amazing  :p
Very good work
 
Back
Top