-
If you have bought, sold or gained information from our Classifieds, please donate to Group DIY and give back.
You can become a Supporting Member which comes with a decal or just click here to donate.
WTB neve marconi knobs for (2) ez1073 1U rack builds
- Thread starter Romanp
- Start date
Help Support GroupDIY Audio Forum:
desol
Well-known member
- Joined
- Jun 20, 2005
- Messages
- 2,128
If you think that's expensive, try contacting Neve. I did.
They wanted 27gbp each + shipping. At today's rates, in Canada(where i am), that 's $48 bucks a piece!
I was here 'years ago when people were pining over these knobs. I'd say that's a good price, not to mention the fact that it's pretty cool they're even available!
They wanted 27gbp each + shipping. At today's rates, in Canada(where i am), that 's $48 bucks a piece!
I was here 'years ago when people were pining over these knobs. I'd say that's a good price, not to mention the fact that it's pretty cool they're even available!
Winetree
Well-known member
Just make sure that the shafts on the pots are long enough.
I couldn't use the CAPI knobs on the NV73 or 2254.
I couldn't use the CAPI knobs on the NV73 or 2254.
simonsez
Well-known member
useme2305
Well-known member
that's a nut.
Winetree
Well-known member
So if the shaft is to short,
you have to remove the nuts,
to make the knob fit.
you have to remove the nuts,
to make the knob fit.
simonsez
Well-known member
Winetree said:
hmmm....nut?
..okYes, remove the nuts, or replace it with nut from potentiometer , and you're done....(I did)
