Hai!
I mostly hang around over at the DIYStompboxes forum but for this one I need to enter the holy realm and magical grounds of GroupDIY.
I countered a problem recently. I cannot insert hardware into my interface without the minimum of 14ms latency, and that does not work very well when you need to treat a signal in real time and be able to hear it in the cue/headphones. I want to treat a mic that needs a little shelving push (5-8dbs) at 100-150hz and 10khz.
I sketched up a very basic idea for this but I need some help on which EQ (no inductors, transformers or +100vcc) I should go with? Would the Poor Man's Pultec EQP1-A be a good choice perhaps? Let me know what you think!
Link to full sized image : http://i.imgur.com/AHYA6G3.png
Link to alternate color scheme (easier on the eyes) :http://i.imgur.com/i8jOezX.png
I mostly hang around over at the DIYStompboxes forum but for this one I need to enter the holy realm and magical grounds of GroupDIY.
I countered a problem recently. I cannot insert hardware into my interface without the minimum of 14ms latency, and that does not work very well when you need to treat a signal in real time and be able to hear it in the cue/headphones. I want to treat a mic that needs a little shelving push (5-8dbs) at 100-150hz and 10khz.
I sketched up a very basic idea for this but I need some help on which EQ (no inductors, transformers or +100vcc) I should go with? Would the Poor Man's Pultec EQP1-A be a good choice perhaps? Let me know what you think!
Link to full sized image : http://i.imgur.com/AHYA6G3.png
Link to alternate color scheme (easier on the eyes) :http://i.imgur.com/i8jOezX.png