Hello everyone. First time posting on here.
I'm in the planning stages of a project that basically involves turning a guitar pedal into a rack mount line level audio processor. I'm not very experienced with electronics so I'm a bit lost. I have a 10k/600 ohm transformer wired from the output of the circuit to act as a DI pretty much. Where I'm lost is the input part of it, I'm going to go from the line out of my D/A into the input of the Dyna Comp, which has an impedance of 1M ohm . I notice there is a loss of level in the signal when I patch it in going straight from the D/A into the input. What should I do?
My apologies for the lack of electronics knowledge. This is going to be my first real DIY project.
I'm in the planning stages of a project that basically involves turning a guitar pedal into a rack mount line level audio processor. I'm not very experienced with electronics so I'm a bit lost. I have a 10k/600 ohm transformer wired from the output of the circuit to act as a DI pretty much. Where I'm lost is the input part of it, I'm going to go from the line out of my D/A into the input of the Dyna Comp, which has an impedance of 1M ohm . I notice there is a loss of level in the signal when I patch it in going straight from the D/A into the input. What should I do?
My apologies for the lack of electronics knowledge. This is going to be my first real DIY project.