soundsactive
Well-known member
Hey all!
I have a re-201 with a rev D PS board. It was working fine, after a few minor repairs I did, but now when turned on the motor and VU light won't go on. They are both off the same winding on the transformer.
When I tested some voltages I was getting very low readings, in the microvolts area. The continuity is pretty good across output pins on the board, 44, 45, 46. The rectifier seems to be fine, but voltages are low. I also can't seem to find a good schematic with voltage readings save for the service manual, which points to +15v to the DC motor circuit, which I am absolutely no where near.
Anything I should check? Is it possible that the transformer is kaput? Thanks!
I have a re-201 with a rev D PS board. It was working fine, after a few minor repairs I did, but now when turned on the motor and VU light won't go on. They are both off the same winding on the transformer.
When I tested some voltages I was getting very low readings, in the microvolts area. The continuity is pretty good across output pins on the board, 44, 45, 46. The rectifier seems to be fine, but voltages are low. I also can't seem to find a good schematic with voltage readings save for the service manual, which points to +15v to the DC motor circuit, which I am absolutely no where near.
Anything I should check? Is it possible that the transformer is kaput? Thanks!