AML Preamplifier General Question

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

jorrharris

New member
Joined
Apr 12, 2024
Messages
1
Location
USA
Hello, I am new to DIY electronics and I have a question about powering these units for calibration. The steps say to power up the module, test specific points, and then adjust the bias knob until you get a certain current. My question is, how are you guys powering these things up? Are you putting it in a 500 series chassis? I am assuming that makes it really difficult to access the test points and turn the bias knob. Do you open up the 500 series chassis for easier access to the inside of the module? Or are people powering these things some other way? Sorry for the noob question.
 
Back
Top