GroupDIY

General Discussions => Truth Table => Topic started by: mg73 on November 20, 2019, 01:31:02 AM

Title: Rotary switch encoder problem
Post by: mg73 on November 20, 2019, 01:31:02 AM
Bought an MPC with a broken encoder according the previous owner
bought a new one same problem then got an replacement from the seller, same problem.

So I suspect that the MPC is not register the encoder correct
I tried with a encoder with less detents and that worked
so I reckon that MPC is sensitive to how narrow the pulse width is from the encoder,
not sure i'm definitely not an switch encoder-pro.

Any idea where to start to look?
the 5v is good, and both legs on the encoder have it thru the 4k7 resistors

Attached schematic.
Title: Re: Rotary switch encoder problem
Post by: mg73 on November 30, 2019, 03:57:41 AM
Seller was full of sh*t sold me two bad ones >:(
Borrowed a friends MPC same problem!
Title: Re: Rotary switch encoder problem
Post by: Whoops on February 07, 2020, 09:36:25 PM
Contact Akai and buy the replacement part from them