[zebra50]

Thought I'd share...

Surgical spirit (is this rubbing alcohol in the US?) works well for removing the decals/labels/transfers from MXL 2001s, and doesn't touch the paint below. My modded mic is now black all over and looks a lot less MXL and a lot more neumannU87-esque.  You need to rub with some cotton wool for a few minutes.

Now I just need a neumann logo to complete the look!

[fum]

Thanks for sharin!  

For those of you not chemically inclined, 0000 steel wool will also do the trick.

Tada!  No more MXL  :green:  :thumb:  :guinness:

Too bad they got smart and stamped the V67 =)

[adrianh]

You all beat me too it.
I was wanting to do this and since the logos are put on
with a silkscreen (or pad printing for curved objects). All you need is alcohol  
to remove it. I would suggest 99% Isopropyl you can get it at the drug store.
Seal it very tightly as it sucks up water in the air and gets comtaminated.
Put it in a flexable plastic bottle and squeeze the bottle before caping to remove most of the extra air. Yes this stuff makes a very good pc board cleaner just keep it in a tight container.

advice on removing inner mesh on mics

Started by pucho812 The Lab

MXL shotgun mics? Anyone use them?

Started by Svart Brewery

Inkjet transfer decals on black chassis problem.

Started by bitman The Lab

Front panel decals

Started by sheadstedford Drawing Board