Echo North
Well-known member
Hi,
I checked the search function and had no luck....here goes.
I have my chassis all drilled up for racking my PM1000 strips. I have brackets to hold in the strips, power supply ect. I'm drilling up from the bottom.
What is the best way to do this? Just a hole then use a bolt? Tapping bit (not even sure what that is?).
What are the basics for making small screw holes in a chassis?
Thanks,
Mike
I checked the search function and had no luck....here goes.
I have my chassis all drilled up for racking my PM1000 strips. I have brackets to hold in the strips, power supply ect. I'm drilling up from the bottom.
What is the best way to do this? Just a hole then use a bolt? Tapping bit (not even sure what that is?).
What are the basics for making small screw holes in a chassis?
Thanks,
Mike
