I'm still on the error search in my GSSL.
There came a general question up to me:
I measured every resistor before soldering it. After setting it in it has got another value than outside.
E.g: 1k before and 760 Ohm after putting it in the board. Measured directly at the resistor itself, not at the soldering joints.
Is this normal - and why? Kirchhoff's law?
If not - what possible error could this be?
There came a general question up to me:
I measured every resistor before soldering it. After setting it in it has got another value than outside.
E.g: 1k before and 760 Ohm after putting it in the board. Measured directly at the resistor itself, not at the soldering joints.
Is this normal - and why? Kirchhoff's law?
If not - what possible error could this be?