1073 1084 with EQ DIY project HELP THREAD

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
I got my first channel going I notice when I switch in the eq though I get a volume boost it also sounds a little more bassy or major h.f roll off is this normal I have never heard a 1084 plus I don't have anything to test it a scope and such.Sounds really really good so far

Thanks
 
Is there any interest in good concentric switches for the 1073 and 1084? Not shooting for originals here, just elma through the whole thing like B.A's remakes and probably Omeg or Bourne's pot coupled to the shafts?

Been digging for information lately and since the concentric stuff is considered custom for Elma it places minimums up there.

04's for gain, 01 for switches except on the 1084 we swap a 01 to a 04. Still working on numbers and it won't happen for about 2-3 months, possibly the first of 09.

These wont work for the 1081 and vise versa, do some homework before asking.

Kevin
 
Hello

ok , ok ..... ,  "old thread" but perhaps the most appropriate found , "running" inside groupdiy ...
anyway.....
the question is about a capacitor placed in the output transformer
in "series" with the 1k5 resistor (as in image attached)

it is a:
polyestere , polypropylene, polysterene type ?

metallized or non ?

thanks in advance
R.



 

Attachments

  • 73-trout.jpg
    73-trout.jpg
    16.6 KB · Views: 5

Latest posts

Back
Top