bernatvm said:... readings between pin 2 and 1 on the input XLR are 44.6V. Same between pin 3 and pin 1. Any ideas? Is it too low?
kambo said:maybe google
DC blocking caps on phantom power schematics
bernatvm said:That's without a microphone pluged
bernatvm said:With microphone pluged i get 1.8V, which i can see is a very bad reading I'm using Bo-hansen phantom psu, attached. Also I have a resistor between the + on the psu and the two 6k810 to reduce voltage, because it was 52 V without mic plugged in.
Enter your email address to join: