Basic Direct Box Plans? Cinemag CM-DBX ?

Hi all.
I have 2 Cinemag CM-DBX "Direct Box" transformers and would like to build, well, a DIY Direct Box that suits my application...

I'd like to be able to feed it unbalanced TS (1/4" from a synth) and then have it put out a signal so I can plug it into my consoles mic pre (XLR jacks).

I have the data sheet from Cinemag but am unclear on what circuit to use & if its right for my application, or maybe there are other ways I can try.
Are there any simple circuits/diagrams demonstrating the proper way to wire these bad boys up?

Suggestions ? Parts / Component Values?

I will be housing it all in a small metal project box so I can plug various synths into it.


Thanks in advance.

There are a couple of designs on this site if you look, but I used the schematic posted at Jensen transformers for my DI I built with a Cinemag.