ilfungo

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #980 on: January 13, 2019, 07:56:48 AM »
Hi abbey road d enfer!
Have you trying something for LF distortion?
Thanks!


ilfungo

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #981 on: January 20, 2019, 07:52:08 AM »
???

ilfungo

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #982 on: January 23, 2019, 01:23:22 PM »
After 2 weeks of testing and no solution for LF distortion
I've tried the IK precision comp/limiter and the results are the same Low Frequency distortion on limiter section!
Attached 2 screenshots plug vs real
The only difference is the limiter on 33609 kick in earlier that IK...

ilfungo

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #983 on: January 23, 2019, 01:24:09 PM »
This is the 33609

Dynamex1

    Upper Franconia, Germany
  • Posts: 4
Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #984 on: June 28, 2020, 09:02:43 AM »
Not sure if i am right here, but:
Does anyone know, if you can get Boards for the 33609 ?

I know that DIY Racked offers a Kit, but i ´m not sure if i´ll go with the original Design and second, i´ve ordered a Kit from them and updates / help isn´t that great, so i will not but again from them, if i can get it from somewhere else.


Kind Regards, Christian

Biasrocks

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #985 on: August 09, 2020, 01:09:04 PM »
Built this quite a while ago and found that the BA340 on the bottom board overheated and self destructed.

Did anyone figure out how to effectively mount a heat sink to the BA340 boards?

Mark
http://SharktankPro.com

"I'd rather use an SPX90 than a UA plugin....." Joe Barresi

opacheco

Re: Official 33609 builder's tread. See 1st page for updates.
« Reply #986 on: August 09, 2020, 05:17:44 PM »
Built this quite a while ago and found that the BA340 on the bottom board overheated and self destructed.

Did anyone figure out how to effectively mount a heat sink to the BA340 boards?

Mark

Do you have any pic of this damage board?, What do you believe could be the problem for?
Thanks for your information!
Opacheco
I love the Vaccum Tubes Sound!!!


 

Related Topics

  Subject / Started by Replies Last post
574 Replies
122262 Views
Last post September 10, 2017, 07:09:43 PM
by skidmorebay
16 Replies
6353 Views
Last post April 23, 2009, 04:42:42 PM
by MrZpliff
43 Replies
9424 Views
Last post October 23, 2009, 08:51:55 PM
by danjpiscina
6 Replies
2333 Views
Last post November 21, 2011, 09:43:41 PM
by Ethan