[mrclunk]

Hi,
 i'm stereo linking a couple of Urei Model 1A's (basically 1176 rev F circuit)
I've built into one of them the 1176SA stereo adapter circuit but its needs a 1.4v battery for ref voltage.
I'm assuming as the battery expires the units will drift out of alignment so i'd like a regulated supply instead.
going to try a simple LM317 circuit hanging off the +30V PSU rail.

Will this do anything weird to the rest of the circuit?

Or would i be better of matching the fets between units and not bothering with the 1176SA approach.
regards
paul

[gyraf]

You can't use any voltage referenced to local ground - the whole circuit after the FD300 diodes are hanging "floating" at a trimmed FET-offset-voltage. (look closely at the schematic..!)

Don't worry about battery life - current drawn is close to zero.

Jakob E.

[ioaudio]

you could use a small 1,4v solar cell powered by leds.

[mrclunk]

ah ok, i'm being a prat!
I'll just screw an AA battery holder to the back an be done with it.

solar cell ideas cool though!

Single rail vs. dual rail in op-amp circuits

Started by Samuel Groner Drawing Board

From 30V down to 3.3V

Started by Rochey « 1 2 » Drawing Board

PSU -30V DC Help!

Started by thekid777 The Lab

FS: Lundahl LL 1528, 1176 Stereo Link, M.NATS PSU

Started by Gedan Black Market