How does one hook up the EA1166 transformer to neve circuit? I see the pdf on the hairball site, but I'm still confused about the wiring compared to original schematic.
I have two of the older (larger EA1166)
For the primary, orange and yellow tie together? Brown or Red goes to the +24V ("M" on the BA283 schematic)
On the secondary, there's usually the 1.5K and .01uF cap in between the hi and lo outs.
So, for a 600 ohm out tie blue and purple together and use green and grey correct? But which is hi and which is low (and which connects to the resistor, which to cap?)