[antoniosolo]

I have searched and searched.....Need to supply two m460 pre's....Thanks in advance...gobble gobble....

[PRR]

http://wbsps.kuzub.com/
http://wbsps.kuzub.com/manuals.htm
http://wbsps.kuzub.com/PDFs/M470A%20Input%20Module.pdf

Power requirements: +/-25 volts dc, 20mA nominal, 80mA maximum

Peeping the module plan, it is very slightly voltage-sensitive. +/-24V will be fine. +/-18V should work fine. +/-12V gives up headroom and also gets you into a trace of crossover distortion (WBS biased output pairs with resistors instead of diodes).

By the specs, you "could" need 2*80mA = 160mA for a pair. But that could only happen with 600R load on the Insert and a totally-clipped signal. I can't see how even "normal overload" could ever exceed 100mA/pair.

A +/-24V 100mA supply should be easy to turn up.

[antoniosolo]

 PRR  thanks for replying.....  I have the W625B, I just need the pinouts off the psu connectors on the back to get some type of cable(IEC?) with male/female to mate and connect those leads to elco's inside of rack case of pre's.  Did that make sense???

[PRR]

There is a 485 +/-25V supply at the URL I posted. Does its connector look anything like yours?

[antoniosolo]

I am a member of that forum.  No, there is no picture of the connector there, at least that I could find.......The amphenol connectors on the back are labeled P1 and P2.  One side is for 110ac and the other is for P48 and lights.  That's all I have grasped thus far.  PRR thanks for your help and I really appreciate any facts you can find for me.

Ward Beck mixer finally rehabbing. Completely. Help please!

Started by Christian The Lab

ward beck m406b compressor schems? NOW WITH PICS!

Started by outoftune The Lab

Ward Beck M470A phantom power issue.

Started by steenamaroo The Lab

Ward Beck M402B schematic

Started by StudioSQ The Lab