Adjusting the attack time on mnats G1176???

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

casrec

Well-known member
Joined
Jan 11, 2009
Messages
131
Location
San Diego
Hello,
    I Didn't really know where to post this so I just started a new one. My question is, I want to adjust the attack on the mnats board which I am guessing is the same as the original 1176 from 8microseconds-800microseconds to 8microseconds-8milliseconds. Can I achieve this buy adding or changing the resistor between the ccw and wiper lugs on the pot. Also, how would I test the time of the attack. I love the fast attack of the 1176 but if I could l would like to make it a little more flexible. Any info would help!

Thanks,
Brandon
 
You should move this into the 1176 general thread.
The original was 20usec - 800usec attack time (approx).
Try increasing the value of the attack pot (currently 25K) to increase the attack time.
The short attack is set by R76//R77, the long attack is set by R77 only (since R76 and C22 are shorted out).

 

Latest posts

Back
Top