TheGuitarist
Well-known member
So i've found a great deal on ebay for some mixing desk channel strips (not vintage neves but hey, aussie vintage jands, not bad stuff)
And i was wondering, how would i go about working out what pins (its set out like a computer card that would slot into a main board by the looks of it) do what and how much power is required to run the unit (with phantom power too)
Obviously i'd need 3 for input, 3 for output, 3 for an insert (i'm assuming) then whatever for the power. I guess there would definately be redundant pins left over as i wont have any sub mixes or panning.
If anyone could point me in the right direction that would be great.
And i was wondering, how would i go about working out what pins (its set out like a computer card that would slot into a main board by the looks of it) do what and how much power is required to run the unit (with phantom power too)
Obviously i'd need 3 for input, 3 for output, 3 for an insert (i'm assuming) then whatever for the power. I guess there would definately be redundant pins left over as i wont have any sub mixes or panning.
If anyone could point me in the right direction that would be great.