GSSL CRC Board and grounding
« on: November 19, 2015, 06:42:17 AM »
Hi all,
Just wanted to share some graphs of my new GSSL build.
I added the CRC board, and then moved the main board grounds from the xlr in/outs to where the crc joins the main board.  Much better!!
Anthony :)


Re: GSSL CRC Board and grounding
« Reply #1 on: November 19, 2015, 06:43:34 AM »
The previous post is my Apogee AD8000 graph.
Below is the stock GSSL.

Re: GSSL CRC Board and grounding
« Reply #2 on: November 19, 2015, 06:45:35 AM »
...this is with the CRC board added...

Re: GSSL CRC Board and grounding
« Reply #3 on: November 19, 2015, 06:46:37 AM »
...and finally, with the grounds moved.  Thanks!

alexc

Re: GSSL CRC Board and grounding
« Reply #4 on: November 21, 2015, 11:40:34 PM »
Nice!   Well done.
I ping therefore I am

Re: GSSL CRC Board and grounding
« Reply #5 on: November 22, 2015, 02:03:11 AM »
Could you check what happens with no CRC board as a go-between and moving to ground to the power input?

Im curious, since adding the CRC board in itself didn't  seem to make a change, based on your data.

Gustav
« Last Edit: November 22, 2015, 06:05:46 AM by Gustav »

critterkllr

Re: GSSL CRC Board and grounding
« Reply #6 on: November 24, 2015, 02:06:37 PM »
Can you explain how you are grounding this? You simply removed the ground wires from the XLR in/out terminals and connected it to the 0V transformer connection?

Whoops

Re: GSSL CRC Board and grounding
« Reply #7 on: April 21, 2017, 09:20:00 PM »
Can you explain how you are grounding this? You simply removed the ground wires from the XLR in/out terminals and connected it to the 0V transformer connection?

yes please,
that would be nice and really helpful

thanks