GreenPre questions

Hi all!
Im getting done with my 8 ch GreenPre but i've got some questions.
Please look at the picture and answer these questions:
1. Resistance?
2. Resistance?
3. Resistance? (My guess 10K)
4. Where to connect the red wire seen on Peters PCB?
5. There is printed on the pcb's both 100nF and .1uF, but that is the same value. Why? Nothing to care about?
6. right where the red wire seems to be connected on peters pcb there should be a link, but as far as i can see there is no link connected. No link or link?

HT

Ask Peter for the setup text file. I had the same question about the red link. You can leave it like you have it with no link from that hole if you want post trim metering. If you want pre-trim then the wire goes from the hole to the right hole on the link right next to the 100k trimmer.

As for the resistance questions. I believe those were all 10k.

Daniel

Hi Tom

All the resistors are 10k.

100nF is equivalent to .1uF

The link is an option to have the meter pre or post the output trim control.

It seems like some people have not received all the setup documentation, so I will email all the docs to all of those who got the PCB's from me.

Regards
Peter

Hi Tom

All the resistors are 10k.

100nF is equivalent to .1uF

The link is an option to have the meter pre or post the output trim control.

It seems like some people have not received all the setup documentation, so I will email all the docs to all of those who got the PCB's from me.

Regards
Peter

Cool!
Thanks!

HT