Chandler Limited LTD-2 meter calibration
« on: May 15, 2019, 03:00:44 PM »
Is there not a GR meter calibration for the Chandler LTD-2?  I see one trim pot on the B283 amp board, which I assume is to bias T3.  There's another trim pot, which the wiper appears to go to the B283 board also.  I believe this is an output level trim.  It looks like the meter drive comes from the B185A control board. 

I have a stereo pair.   I traced through both units taking measurements and as far as audio, both units perform identically.  It turns out the difference in GR metering just comes down to a difference in the meters themselves.  I used some gator clips and crossed the meters from each unit and connected to the other.  The difference in meter level stayed with the meters.


Re: Chandler Limited LTD-2 meter calibration
« Reply #1 on: May 15, 2019, 05:18:23 PM »
did you hit up chandler ltd?
You tell me whar a man gits his corn pone, en I'll tell you what his 'pinions is.


Re: Chandler Limited LTD-2 meter calibration
« Reply #2 on: May 17, 2019, 04:57:06 AM »
The meter was connected to the B192 in the 2254, no trimmer only two resistors in serie with the meter for 1mA or 500uA.
10k for 1mA meter and 10k + 10k for 500uA.
Thomas "TK" Kristiansson
"The Sound Is In The Iron"


Related Topics

  Subject / Started by Replies Last post
10 Replies
Last post August 15, 2008, 08:19:53 PM
by RAM
0 Replies
Last post May 28, 2009, 12:51:39 PM
by electrochronic
1 Replies
Last post November 25, 2012, 12:37:39 PM
by Kid Squid
0 Replies
Last post September 20, 2011, 01:14:46 PM
by martthie_08