[Adky]

I am having a hum issue (unknown if it is a ground hum) when the output is turned to 2 or 3 o'clock the hum is not audible, but anything over is a problem.  is this normal for G1176's?  The unit does not have an input transformer, but does this make a difference?  the circutry has an input transformer, but the circut is open.  I also can not locat a 4M7 trim pot for the release, ( I used 2x 2M daisy chain ) so is there anything that i can use to substitute?  if not, what other options are there?
Thank!!!!

[matthias]

did you cut the ground plane like it's shown in the 1176help thread??

[Rob Flinn]

for 4m7 pots check this thread
http://www.groupdiy.com/index.php?topic=2996&highlight=4m7&sid=5ce76df578d93343e6f6e22ff41a78ce

[Adky]

Thanks!!!
Mat:
Can you please direct me to the thread?
Is pretty hard to find and I think I got lost in the jungle :cry:
Thanks again!!!

[Adky]

I performed the  " TRACE CUT " and Installed a Fat Ground Cable ,, Now I can Have it Crank-up about 3 or 4 O'Clock Position
BTW: the Monitor are actually pretty Loud  :grin:
VERY THANKSFULL
I will Post Pict Later On-----THANKS AGAIN GUYS

dynamic mic problems please help

Started by frob The Lab

9K... Phantom problems... noise... hum and hiss...

Started by Neeno The Lab

Calrec EQ - PCB re-design - Prototype phase

Started by sonicwarrior « 1 2 » The Lab

LL5402 vs Edcor prototype in a G1176

Started by jensenmann The Lab