Just as I had resigned myself to having to etch my own fingerboards for some DIY projects to fit in my DBX 900 case and API 500 case I was turned on to this:
http://www.vectorelect.com/Product/Plugbord/Layout/3797-2%20Layout.pdf
I think the 15 pin edge finger board would work. From my line up against the screen of my 500 card the pins fit exact. The full edge maybe a little longer but I doubt they would make these and they not fit a standard 15 pin edge connector. Even if the don't - I could sand down the side.
Combine this with an "L" Bracket and I got a bunch of stuff converted to either series.
BTW: I put a JLMaudio 5 power rail supply in my DBX 900 case so I have phantom power for some preamps!
Seems that Digikey is out of stock but said they have a lead time of about 1 week. I've seen a supplier selling them for $15 USD.
Thoughts?
CC
http://www.vectorelect.com/Product/Plugbord/Layout/3797-2%20Layout.pdf
I think the 15 pin edge finger board would work. From my line up against the screen of my 500 card the pins fit exact. The full edge maybe a little longer but I doubt they would make these and they not fit a standard 15 pin edge connector. Even if the don't - I could sand down the side.
Combine this with an "L" Bracket and I got a bunch of stuff converted to either series.
BTW: I put a JLMaudio 5 power rail supply in my DBX 900 case so I have phantom power for some preamps!
Seems that Digikey is out of stock but said they have a lead time of about 1 week. I've seen a supplier selling them for $15 USD.
Thoughts?
CC