Neve 500 series 1084 eq... pre orders.. CLOSED

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Hey Peter, thanks, it's looking very good.   :)

Regarding output iron, are you aware of the new Lundahl based on the LO1166?  http://www.lundahl.se/pdfs/datash/2734.pdf  It could be soldered right onto your board, if it fits.  Would have plenty headroom.

:eek:
 
peter purpose said:
tommypiper said:
Where did you get the shiny 31267 mounting bracket?  

From some old Audix modules.
Tim at SCA has them.

Just heard back from Tim.  He has them manufactured, and won't sell them.  Apparently they are part of a kit or something.  

So, an odd part to be sourced for your PCB...  It's probly easy enough to DIY them from copper or tin  sheet... :)
 
So, an odd part to be sourced for your PCB
No. The holes in the pcb line up with the screws in the Carnhill casing.

are you aware of the new Lundahl
I wasn't, but am now. Still too big anyway.

Any more news Peter?
Some shitcunt tried to blow up a plane.

 
Hey Peter,

Hope you had a good crimbo.

I see you used a marinair traffo there.  Do you happen to know whether the marinair screws line up the same with a carnhill?  Also is it the same size physically or bigger than a Carnhill?

Cheers.

No worries if not

 
peter purpose said:
Avec knobage et sweesh.

possfp842.jpg

Maginifique! You got the x-factor equivalent of electronics! DC-Factor or AC-Factor or stg like that :)
 
OK boys,
Ed is nearing completion of the output transformer development and AndyP reckons my poo doesn't stink with this module, so what I will be offering will be.........

PCB set (mainboard & amp boards)
500 series metalwork
mounting hardware
2 toggle switches
Heatsink
Sockets & pins for the amps
P&P included

That lot will set you back 135GBP per channel, plus 4% paypal fees.

If you're up for it.... paypal (at) lazpro.com
 
Hi,

Some (hopefully not stupid) questions:

1) Is there a BOM available?
2) Are the inductors, trannies or grayhills custom jobs?
3) Do the rockers replace the toggles as seen in the photos?
4) Does the 500 metalwork include the front panel?
5) Does P&P mean postage/shipping?
6) Is this my last question?  :p

Thanks!
Chris
 
Back
Top