renx
Well-known member
Hi everyone,
The biggest problem for me, and as for many of you when building a microphone, is its body. Enormous problem to make and even greater problem to make it look good diy. This afternoon I received 5 different microphone body samples which can be ordered, from where else but China.
The manufacturing quality is pretty good. Same or better than Behr*ing*er.
The bodies include PCB mounting brackets, 3pin and 7pin male connectors.
The shockmounts seem pretty good too.
Here are more pics:
mic1:
http://img684.imageshack.us/g/picture002t.jpg/
mic2:
http://img707.imageshack.us/g/picture010e.jpg/
mic3:
http://img692.imageshack.us/g/picture016vj.jpg/
mic4:
http://img692.imageshack.us/g/picture018t.jpg/
mic5:
http://img707.imageshack.us/g/picture024w.jpg/
I haven't measured the exact sizes yet, but I will soon.
Those three bigger bodies would roughly cost under 100$ each, and the smaller two around 10$ less.
The shockmounts would cost 30$ for the bigger one and 10$ for the smaller one.
The minimum order I can make is 100 pieces of each body.
Is anybody interested in these bodies?
Regards, Renx.
The biggest problem for me, and as for many of you when building a microphone, is its body. Enormous problem to make and even greater problem to make it look good diy. This afternoon I received 5 different microphone body samples which can be ordered, from where else but China.
The manufacturing quality is pretty good. Same or better than Behr*ing*er.
The bodies include PCB mounting brackets, 3pin and 7pin male connectors.
The shockmounts seem pretty good too.
Here are more pics:
mic1:
http://img684.imageshack.us/g/picture002t.jpg/
mic2:
http://img707.imageshack.us/g/picture010e.jpg/
mic3:
http://img692.imageshack.us/g/picture016vj.jpg/
mic4:
http://img692.imageshack.us/g/picture018t.jpg/
mic5:
http://img707.imageshack.us/g/picture024w.jpg/
I haven't measured the exact sizes yet, but I will soon.
Those three bigger bodies would roughly cost under 100$ each, and the smaller two around 10$ less.
The shockmounts would cost 30$ for the bigger one and 10$ for the smaller one.
The minimum order I can make is 100 pieces of each body.
Is anybody interested in these bodies?
Regards, Renx.