dagoose
Well-known member
Since the soundskulptor tape simulator is avalaible now and i'm already building mine and to keep the white market topic a bit clean this is going to be the support thread. ;D
I already have a question concerning the VU meter board because there seems to be a mistake, there are 2x R20 marked resistors positions and i think that R16(?) is missing on the board so i guess that should be it but not sure which one.
the original value for R20 = 220k and the other resistor marked as R20 = 330r.
Which one is the REAL R20? the one near the trimpot or the one between the lm339's?
I'm building mine in a 1u case with 24 steps stepped attenuators, one for input and one for output so just 2 knobs for IO's.
I will post my panel later on when done.
More info: http://www.groupdiy.com/index.php?topic=33492.0
I already have a question concerning the VU meter board because there seems to be a mistake, there are 2x R20 marked resistors positions and i think that R16(?) is missing on the board so i guess that should be it but not sure which one.
the original value for R20 = 220k and the other resistor marked as R20 = 330r.
Which one is the REAL R20? the one near the trimpot or the one between the lm339's?
I'm building mine in a 1u case with 24 steps stepped attenuators, one for input and one for output so just 2 knobs for IO's.
I will post my panel later on when done.
More info: http://www.groupdiy.com/index.php?topic=33492.0