Calrec Parts List - mouser or digikey?

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

thedug

Well-known member
Joined
Jun 13, 2004
Messages
235
Just curious if anybody has a mouser or digikey parts numbers for the calrec project?

d./
 
I was just looking at the parts list and can anyone tell me what a 3pin led is?
 
I noticed that the tantalum caps are 16V. If I run the eq at 18V will I need to get bigger caps?

Also, anybody know of some cheap tantalums? The cheapest I found at mouser are $1.5 and at 48 of them that adds up!

d./
 
Well considering that I bit the bullet and ordered my parts.

I"ll just forgo that. =P


d./
 
That was an intersting thread. Seems to reinforce my thoughts to replace tantalums with tantalums. :p

Althought I did job down the names of those caps.
 
so will 10v work if you use the 18v or 15v power source option,
or do you need the 16v, they are still 1.5$, it adds up quick.
 
the 3 pin LEDs are bi colour LEDs
If I remember rightly it is green for on, red for bypass....
 
Back
Top