Euros: shallow rack case?

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

eskimo

Well-known member
Joined
Mar 30, 2006
Messages
592
Location
Sweden
Where to find?
My builds are usually p2p tube ones with everything mounted on the front and back panel, so the deep cases available are a bit annoying. Something 15-20 cm deep would be nice.
 
http://www.holtbs.co.uk/joggle_cases.htm

Doesn't look bad! However, they have their own way of mounting the front panel, which makes getting a separate one harder. I suppose one could use an L bracket or something.
 
Might not be the best answer to your question but:

Diy ?

I made a 19" case last week with 1mm aluminum. 1mm sounds like it's thin but it's the same as a hammond tube amp case, it's pretty strong.
Just cut out the alu with a sharp knife, than lightly cut a few times to make the folding edges.
An off-the-shelf case would have been cheaper in hourly rates, but it's custom built and it looks really ok! (i think)

http://i391.photobucket.com/albums/oo352/arnolievens/medium6.jpg
http://i391.photobucket.com/albums/oo352/arnolievens/medium5.jpg
http://i391.photobucket.com/albums/oo352/arnolievens/medium4.jpg
http://i391.photobucket.com/albums/oo352/arnolievens/medium2.jpg

I know, I know, greasy fingerprints...
 
Heh, well, I have a hard time enough doing the metal work for the tubes!
That is impressive though, nice work!
 
Back
Top