Brolik
Well-known member
Hey guys. I know that this is a waste of space and bandwidth and whatnot... but I've got to ask a pure n00b question.
I'm building the Drip V72 and I have a sweet Jantzen Superior Z 2.2uF cap that I am hoping to use as the output cap (C33). The problem is that the requested value is 2.0uF. I feel like this falls (close anyway) within a 10% tolerance, which I understand should be fine. I want to make sure that it will be though.
It's an expensive cap and an expensive build, so I don't want to make stupid mistakes, even at the cost of asking stupid questions.
Here's a link to the .pdf about the project. http://dripelectronics.com/documentation/v72_pcb_manual.pdf
Thanks in advance, and I apologize again for stupid questions.
I'm building the Drip V72 and I have a sweet Jantzen Superior Z 2.2uF cap that I am hoping to use as the output cap (C33). The problem is that the requested value is 2.0uF. I feel like this falls (close anyway) within a 10% tolerance, which I understand should be fine. I want to make sure that it will be though.
It's an expensive cap and an expensive build, so I don't want to make stupid mistakes, even at the cost of asking stupid questions.
Here's a link to the .pdf about the project. http://dripelectronics.com/documentation/v72_pcb_manual.pdf
Thanks in advance, and I apologize again for stupid questions.