Removing pin from Grayhill switch help

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

benlindell

Well-known member
Joined
Feb 28, 2009
Messages
631
Location
NYC
I'm a dummy and accidentally put a pin in the wrong hole on one of my switches, I tried tape and a solder sucker and didn't come out, any ideas?
 
I just did this setting up a switch for my EQN, and I turned it up side down and wiggled the knob while tapping and shaking it (over a dish to catch the pin in). It worked.
If it is really stuck, I have taken grayhills apart to manually set the stops (on non adjustable) and it is possible, but intricate. Don't drink too much coffee first.  :) 
 
i had same problem some time ago.... i had to disasemble switch, remove pin from hole from inside, and then assemble switch again.... it is not big problem, if you have steady hand.
 

Latest posts

Back
Top