kante1603
Well-known member
Dave! What are you talking about.....oh wait...you meant for the microphone?wave said:Also, what body are you using now?
Dave
(Excuse me,couldn´t resist ;D)
Dave! What are you talking about.....oh wait...you meant for the microphone?wave said:Also, what body are you using now?
Dave
muffy1975 said:Guys,
if the 1uf capacitor connected to the output xformer is changed, is it important that the voltage of this capacitor is close to 250V?
If the voltage is higher, does it act as an HPF?
LHS said:Finally got my build finished and the mic works beautifully. How do you guys find it compares to an actual U47? It seems to be more dependent on placement then most U47s I've used. The top end seems to drop off during vocal tracking when the singers shifts their heads even very slighty. 47s certainly aren't overly bright but the drop seems more drastic on these. (using the Dale M7 capsule by the way).
dandeurloo said:Guys, I have kind of a dumb question. When building up my Cable for the tube mic to the PSU should I connect the shielding from the cable to the ground point on the Binder connection on my PSU? I am assuming that at least one end of the shield should be connected to ground and it seems to make the most sense to do it at the PSU but I could be completely wrong.
Thanks as always.
Will be in for two-if I may!zayance said:I'll have some more PSU PCB's for if interested.
T.
ioaudio said:should be approx. 60vdc - re-check resistor values?
I'll take one.zayance said:I'll have some more PSU PCB's for if interested.
T.
Enter your email address to join: