Val_r
Well-known member
Hi folks,
I'm planning to use the AK4101A DIT,
I'm using it as a slave, 24 bit LJ, hardware (syncronous) normal mode.
It is not clear, from the datasheet, how to correctly set the Fs.
In Tables 4 and 5 (page 18 of datasheet) it is explained how to set FS3-0 pins, respectively in consumer and professional mode.
My concern: is 'consumer' the default mode? (so I should use table 4 settings).
Any hints?
Thanks in advance.
I'm planning to use the AK4101A DIT,
I'm using it as a slave, 24 bit LJ, hardware (syncronous) normal mode.
It is not clear, from the datasheet, how to correctly set the Fs.
In Tables 4 and 5 (page 18 of datasheet) it is explained how to set FS3-0 pins, respectively in consumer and professional mode.
My concern: is 'consumer' the default mode? (so I should use table 4 settings).
Any hints?
Thanks in advance.