Hey Guys... Could any of you guys using Dan's case for the EZ120 let me know what standoffs I need to get this board at the proper height for the switch to line up with the front panel? I'm also doing the access312... What size should I get for that?
Not sure myself, I just picked up what was on the BOM but I'm seeing now that the board is going to have to be mounted upside down, or the heatsink fins are all going to need to be almost parallel with the board to clear the top of the case without making contact. I suppose it has a lot to do with which heatsink you use, I've seen some pretty nifty low profile ones but I used standard looking ones that sit pretty tall.
EDIT: I stand corrected, everything fits like a glove. I can't find my tape or caliper sorry Neily, I can check in the morning. Just dry fit one of the grahill switches and measure from there.
These are going to look Very clean, thanks again Dan!
