Hi
I just finished my dual green pres , so thanks to this forum I now have a GSSL , 2x G Pultecs and 2 Green Pres in my project studio.
I did post in the "All Things Green" thread asking if anyone could check if my Green Pre voltages looked right - but its awful quiet on that thread at the moment !
Anyway - I just acquired a used scope - its a Tektronix 465 scope . Unfortunately it had a fall down some steps but seems to have survived miraculously.
I just ran a sine wave through it and seems to be working OK.
2 Questions as I'm a guitar player not a scope expert .....
1) How can I test the scope to see if its working well across its various functions, given its recent fall ?
2) As a beginner when it comes to scopes, how could I use this to learn about/test the green pres I just built ( and my other builds )
all suggestions welcome
Rgds
PeteC
I just finished my dual green pres , so thanks to this forum I now have a GSSL , 2x G Pultecs and 2 Green Pres in my project studio.
I did post in the "All Things Green" thread asking if anyone could check if my Green Pre voltages looked right - but its awful quiet on that thread at the moment !
Anyway - I just acquired a used scope - its a Tektronix 465 scope . Unfortunately it had a fall down some steps but seems to have survived miraculously.
I just ran a sine wave through it and seems to be working OK.
2 Questions as I'm a guitar player not a scope expert .....
1) How can I test the scope to see if its working well across its various functions, given its recent fall ?
2) As a beginner when it comes to scopes, how could I use this to learn about/test the green pres I just built ( and my other builds )
all suggestions welcome
Rgds
PeteC