idylldon
Well-known member
Hello everyone,
I'm planning to use an A11 for a tube pre I'm putting together and found this schematic for selecting the input impedance:
http://www.frontiernet.net/~jff/pultec_mb1/images/DualPultecMB1.pdf
It appears that terminals 1+3 are connected together and are connected to two of the terminals on the switch. The number 2 terminal is separate. Does that appear correct?
Thanks,
--
Don
I'm planning to use an A11 for a tube pre I'm putting together and found this schematic for selecting the input impedance:
http://www.frontiernet.net/~jff/pultec_mb1/images/DualPultecMB1.pdf
It appears that terminals 1+3 are connected together and are connected to two of the terminals on the switch. The number 2 terminal is separate. Does that appear correct?
Thanks,
--
Don