Potato Cakes

Cavendish outputs
« on: November 18, 2014, 11:04:16 AM »
For those of you who have successfully finished the Expat Audio Cavendish mod, could you tell me how you wired the outputs to XLR? I've tried to do my due diligence to figure it out on my own, but what I am a little confused by the photo of it on the build guide as it shows pins 1-5 as being +/-/GND/-/+ respectively. However, when I run down the traces I see that output transformer is fed from the grey conductor and it sends signal to pins 1-5 as Brown/Yellow/NC(GND)/Brown/Yellow. This would cause me to believe that it would be +/-/GND/+/- according to the transformer wiring diagram on CAPI's website. I'd like to finish this up in a couple of days to take it on the road and also post photos of it being completed and show you guys what your generosity of knowledge has allowed me to accomplish. Any assistance would be greatly appreciated!

Thanks!

Paul


SSLtech

Re: Cavendish outputs
« Reply #1 on: December 16, 2014, 07:30:22 PM »
You're correct. The output connector is : +/-/GND/+/- .

Keith
"A waist is a terrible thing to mind"
Quote from: PRR
Ah, but that was 1999; we don't party like that any more.

Rochey

Re: Cavendish outputs
« Reply #2 on: April 07, 2019, 09:10:30 PM »
Expat Audio Home: http://www.expataudio.com