I think I have one more question concerning my Pultec clone (see picture after that I will be able to finish them and finally use them. Quite excited about hearing them...
I used a universal Hammond 370CAX transformer (http://www.hammondmfg.com/300series.htm). I connected the primary windings for 240V, but I don't know what to do with the other primary wires (100V, 110V, etc...). Should I just cut them of and put some heat shrink over them? Or...?
Also with the secondaries I have a question: every filament has a CT wire, even the yellow ones to power up the on/off light. What should I do with them? Just solder them to the ground? Just like the violet (50V) wire, which is also a CT?
Hope anyone can help me out in this final stage.
Thanks!
I used a universal Hammond 370CAX transformer (http://www.hammondmfg.com/300series.htm). I connected the primary windings for 240V, but I don't know what to do with the other primary wires (100V, 110V, etc...). Should I just cut them of and put some heat shrink over them? Or...?
Also with the secondaries I have a question: every filament has a CT wire, even the yellow ones to power up the on/off light. What should I do with them? Just solder them to the ground? Just like the violet (50V) wire, which is also a CT?
Hope anyone can help me out in this final stage.
Thanks!