thermionic
Well-known member
- Joined
- Jun 3, 2004
- Messages
- 1,671
Hi,
I'm trying to put a large schematic for a small mixer into EasyPC. As can be imagined, it's getting very busy with all the various routings.
When I click on 'settings' and 'working area' it will only let me use the screen area from 0 to 38,180 - it won't let me enter a larger figure. On my screen it goes from -22,000 to +62,000.
How can I access this unused area? I can't drag any blocks outside the area defined in the working area.
Thanks.
edit - note I'm only talking horizontal area here. I haven't tried to change vertical area yet...
I'm trying to put a large schematic for a small mixer into EasyPC. As can be imagined, it's getting very busy with all the various routings.
When I click on 'settings' and 'working area' it will only let me use the screen area from 0 to 38,180 - it won't let me enter a larger figure. On my screen it goes from -22,000 to +62,000.
How can I access this unused area? I can't drag any blocks outside the area defined in the working area.
Thanks.
edit - note I'm only talking horizontal area here. I haven't tried to change vertical area yet...
