SaMpLeGoD

Help needed with Neumann U67 and Summit TLA50
« on: June 10, 2013, 12:56:58 PM »
Hello all,

I need to replace some caps on a vintage Neumann U67... 500uF/40V and 25uF/385V
This values are hard to find... if I go with 470uF and 22uF should I get any problem? the fisical space is too tight to fit paralel caps, and as long as they are in the PSU part, I think I'll ge no problem with ripple using this values, am I right?

I need a service manual for the Summit TLA50 tube leveler... I replaced the 12AX7 inside, but need to adjust some trimmers... the sound is way low that with the other used tube. Can anyone help me with this?
Cheers,

E K
Keep on Rockin' and DIYing!!!!


radardoug

Re: Help needed with Neumann U67 and Summit TLA50
« Reply #1 on: June 10, 2013, 05:16:32 PM »
The Neumann will be fine with the close values. Also modern caps are much smaller than the old ones, you can go up a step if you want, but 470 uF is fine for the LV ones.


 

Related Topics

  Subject / Started by Replies Last post
14 Replies
4937 Views
Last post April 16, 2007, 10:35:27 AM
by SSLtech
2 Replies
2787 Views
Last post June 02, 2008, 09:31:46 PM
by Spendor
11 Replies
4629 Views
Last post October 04, 2008, 02:18:15 PM
by electrochronic
1335 Replies
245188 Views
Last post August 13, 2019, 01:29:42 PM
by Joekkel