Hi.
So there is one sweet toy sitting on the table.
I don't have time to play with it anymore. Maybe someone could put it in action.
Here is what it has:
Dual y drive
Dual x rails
Travel 21,5cmX33,5cm
4 stepping motors
Motor Step angle 1.8 deg
Rotor interia 180gcm2
Holding torque 805 mNm
Pull-out torque 573 mNm
Reistance /phase 5.6 ohm
Inductance /phase 12.5mH
Nominal current /phase 1A
Nominal voltage 5.6V
Toshiba LPT motor controller in aluminium box
With microstepping, current limiting, Endswitch inputs, mill start/stop relay. Fully compatible with Mach3.
24V 13A PSU module
Can be sent with pre configured tabletop computer (Mach3)
No mill attached. no bed. Only mechanics and electronics. Preassembled.
Price is 430€ with free shipping with tracking number.
So there is one sweet toy sitting on the table.
I don't have time to play with it anymore. Maybe someone could put it in action.
Here is what it has:
Dual y drive
Dual x rails
Travel 21,5cmX33,5cm
4 stepping motors
Motor Step angle 1.8 deg
Rotor interia 180gcm2
Holding torque 805 mNm
Pull-out torque 573 mNm
Reistance /phase 5.6 ohm
Inductance /phase 12.5mH
Nominal current /phase 1A
Nominal voltage 5.6V
Toshiba LPT motor controller in aluminium box
With microstepping, current limiting, Endswitch inputs, mill start/stop relay. Fully compatible with Mach3.
24V 13A PSU module
Can be sent with pre configured tabletop computer (Mach3)
No mill attached. no bed. Only mechanics and electronics. Preassembled.
Price is 430€ with free shipping with tracking number.