Cavendish outputs

GroupDIY Audio Forum

Help Support GroupDIY Audio Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Potato Cakes

Well-known member
Joined
Jul 1, 2014
Messages
2,258
Location
Nashville, TN
For those of you who have successfully finished the Expat Audio Cavendish mod, could you tell me how you wired the outputs to XLR? I've tried to do my due diligence to figure it out on my own, but what I am a little confused by the photo of it on the build guide as it shows pins 1-5 as being +/-/GND/-/+ respectively. However, when I run down the traces I see that output transformer is fed from the grey conductor and it sends signal to pins 1-5 as Brown/Yellow/NC(GND)/Brown/Yellow. This would cause me to believe that it would be +/-/GND/+/- according to the transformer wiring diagram on CAPI's website. I'd like to finish this up in a couple of days to take it on the road and also post photos of it being completed and show you guys what your generosity of knowledge has allowed me to accomplish. Any assistance would be greatly appreciated!

Thanks!

Paul
 

Latest posts

Back
Top