Info required on old Calrec output transformers
« on: February 22, 2005, 05:54:49 AM »
Just picked up a couple of transformers...
They were salvaged from an early Calrec Quad desk that was sawn in half
Here is a picture of the logo from the desk
Here are the transformers
They are unshielded the make is Electrosonic
The specs are apparantly and I quote -
"10kohm/600 ohm (but I can't be sure of this) centre tapped."

Anybody got any pinouts? and are they any good?
What do I use them for...
They cost me a fiver for both.....

Info required on old Calrec output transformers
« Reply #1 on: March 21, 2005, 05:50:25 AM »
last bump for any information...
thanks guys...


Related Topics

  Subject / Started by Replies Last post
8 Replies
Last post August 04, 2004, 01:08:31 PM
by zebra50
1 Replies
Last post November 18, 2013, 01:09:40 PM
by snafu
3 Replies
Last post October 10, 2011, 04:36:59 AM
by sahib
5 Replies
Last post July 03, 2013, 10:48:00 PM
by mjrippe