avdo
Well-known member
Ian,
How do you test it?
I can't understand what do you do!?
Thanks!
How do you test it?
I can't understand what do you do!?
Thanks!
You can become a Supporting Member which comes with a decal or just click here to donate.
avdo said:Ian,
The task was to achieve a smooth attenuation of the signal.
avdo said:Ian,
Can you show how do you do this test?
envelope said:Hello AVDO
what is the tolerance of the 3 wafers?
Thank You
envelope said:thanks. Can you confirm that the middle wafer is in fact a true Log Taper.
At 50% rotation, a 1K Log taper will measure 10% of total resistance, i.e. 100 Ohms.
with +/-20% tolerance, your part should measure between 80 Ohms and 120 Ohms.
is this the case?
Also (attached is a 'generic' taper graph.)
is it possible to post a similar graph using your new part?
avdo said:Ian, thanks!!!
I will check it at first, when I decide this!
I will send to you again how many do you need!
Please, sorry! I am very not pleased that I did!
Dreams said:Side note:
If you could make these with a smaller shaft diameter, I'd buy a bunch of them.
Enter your email address to join: